Home Technical Discussions Audi TT 2000-2006

Audi TT 2000-2006 Audi TT (2005) fault code 18089 (P1681 - 35 - 00)


Permlink Replies: 3 - Pages: 1 Threads: [ Previous | Next ]
Last Post: May 27, 2010 10:44 AM Last Post By: RickW
wan

Posts: 3
Registered: 01/14/10
Audi TT (2005) fault code 18089 (P1681 - 35 - 00)
Posted: May 24, 2010 4:46 AM
  Click to reply to this thread Reply
Hello....anyone can help me.

Fault symtoms :-

1- This fault can be erased. When i erased fault, that car run normally but after stationary mode, the problem come again. wmen i started the engine, engine warning light comes again and when i pressed throtle pedal, the throtle pedal no respons.

2. I erased fault again and i try drive this car to hard drive mode. Add 1st gear to 2nd gear is ok but at 3rd gear the engine go to safe mode (engine cut) and at the same time engine light comes again.

Fault Code :-

18089 - Control Module Programming Not Finished
P1681 - 35 - 00
Readdiness : 0100 1001

Pleaseeeee..... anyone can help me.... Thanks

RickW

Posts: 718
Registered: 02/16/05
Re: Audi TT (2005) fault code 18089 (P1681 - 35 - 00)
Posted: May 24, 2010 10:07 AM   in response to: wan in response to: wan
  Click to reply to this thread Reply
Hello, wan

Where are you located and what is the engine code. I looked through the factory information for all engine codes for a 2005 Audi TT and did not see a listing for that code.

Rick W
Bentley Publishers
wan

Posts: 3
Registered: 01/14/10
Re: Audi TT (2005) fault code 18089 (P1681 - 35 - 00)
Posted: May 27, 2010 4:42 AM   in response to: RickW in response to: RickW
  Click to reply to this thread Reply
Hi Rick W,

Thanks for your reply, I locate in Shah Alam,Malaysia. Here i give you full imformation about this car.

Make/Model : Audi TT 1.8L Turbo Motronic ( 132kw )
Year : 2005
VIN Number : TRUZZZ8N151015969
Engine Number : AUQ102446
Chassis Type : 8N - Audi TT
Location : Shah Alam, Malaysia

Thanks so much Ricky W....

KR,
Wan
RickW

Posts: 718
Registered: 02/16/05
Re: Audi TT (2005) fault code 18089 (P1681 - 35 - 00)
Posted: May 27, 2010 10:44 AM   in response to: wan in response to: wan
  Click to reply to this thread Reply
Hello again

Thanks for the update. Unfortunately, your engine was not sold in the US market, so we have no documentation for it. As I said, we don't have any information on that code.

However, it sounds to me like you have an adaptation problem, as in a component needs to be run through it's adaptation procedure again.

Rick W
Bentley Publishers

Point your RSS reader here for a feed of the latest messages in all forums

Popular Discussions:
No popular dicussions.