How do I go about fixing the wire? It broke off right where the wire enters the back of the connector. I can't figure out how the terminal comes out of the housing, or I would take the terminal out and solder it and put it back in.
There is a locking tab on one side of the contact that is pushed in by a small flat probe pressed in from the contact side, and then the connector is pushed out the wire side.
The dealer can order repair pigtails that have the contacts on a foot or so of wire, so that one will repair two contacts. Fit the new contact and splice the wire in. They also supply new connector shells, and the cost isn't bad.
So you can experiment with your own repair, knowing you can easily replace the whole connector.
Strange, I buy these kinds of things all the time from my dealer parts dept.
I believe this is the same common 2-pin connector used several places, and if so the wire repair pigtail is part # 000-979-133 (list $4.00), and the connector housing is 037-906-240 (list $4.97).
Never leave your Browser history without deleted,Because any other person can easily able to know what you were browse Before.Get help through this website delete browsing history delete how to remove your history from any others web browser.Thank you so much.